if so, after you double click on the blue bar ... you should get a page that represent the base... and on the top of the page 3 0or 4 tabs click on the update tab
I didn't think of that one at first Joe....could be right. And also download the FULL manual at the V2 base homesite, tab downloads!!! And after that:
Steve, after the restart..you have to calibrate the wheel, when the display says cal push the wheel settings buttonn once, so display shows S-1. Turn wheel by hand to centre. Press '3 striped button and A button' simultaniously to calibrate wheel centre. Then press wheel settings button again. Turn off the base, attache the hub, turn base on again. After calibration the base light is lit green. Press 'double squares and Y' button to get base in pc mode, light should be red and recognised by pc and Fanatec application.
I f this is your fist use of the hub I believe it says to update the hub ... but you may want to check the manual... regardless the procedure is the same and really easy once you are familiar with it... I would suggest you add item one at a time and reflash if needed ... so you can isolate a problem with ad on hardware..
Whoehahahaha, sorry Steve...you couldn't calibrate the base without the hub...I was a little bit to far in steps forward... Thnx for your help Joe!! LoL
In the full latest manual it says to update without hub. Full manual IS just needed to be read with these products. I often find out myself tpp for numerous things...but Fanatec is a different thing...lol
Comments
Han on Joe, I do believe I can get that far...one sec
first ... just the wheel base alone
Ok, first I don't have a "Fanatec" program listed after intstall...only what I see in Program Files
FwBaseULpdateWindow
FwClubSportBaseUpdate
FwClubSoprtUsbUpdater
FwCplWindowWait
All exe files there
How do I get to the controller window, see couple posts above
if so, after you double click on the blue bar ... you should get a page that represent the base... and on the top of the page 3 0or 4 tabs click on the update tab
did the driver package install an icon on you desk top ?
Yes, Club sport is there
HEEEYYY... wait, getting somewhere
this is slow so .... so you opened the controller window and double clicked the blue "clubsport whee"
Steve, after the restart..you have to calibrate the wheel, when the display says cal push the wheel settings buttonn once, so display shows S-1. Turn wheel by hand to centre. Press '3 striped button and A button' simultaniously to calibrate wheel centre. Then press wheel settings button again. Turn off the base, attache the hub, turn base on again. After calibration the base light is lit green. Press 'double squares and Y' button to get base in pc mode, light should be red and recognised by pc and Fanatec application.
no wheel so ... forget that ... close out the windows and power down the wheel
Got GREEEEEENN!!! NOw I just need to wheel center calibrate
YOU GUYS ROCK!!!!!!
I think I got it!!! Damn man, where are the step by step instructions on flashing the bias? I guess here now, or I missed it
lol
I f this is your fist use of the hub I believe it says to update the hub ... but you may want to check the manual... regardless the procedure is the same and really easy once you are familiar with it... I would suggest you add item one at a time and reflash if needed ... so you can isolate a problem with ad on hardware..
Okay, checking that
Thnx for your help Joe!! LoL
In the full latest manual it says to update without hub. Full manual IS just needed to be read with these products. I often find out myself tpp for numerous things...but Fanatec is a different thing...lol
No update requested on Hub, okay, going into Xbox now....fingers crossed