Basic Brake Pedal will just register signal at 50% way since CS DD+
Hey there,
I have the standard basic pedals, brake and gas. When I installed the DD+ I noticed that my brake pedal would only get a signal after it is pressed half way. It will register full brake power at 100% way though. So I basically have just half the way of the pedal that gives out the signal.
Someone suggested cleaning and doing something with the potentiometer, but to me it seems like a software issue, since it was workung fine just an hour earlier.
If I fiddled with the potentiometer, I would need to recalibrate the pedals afterwards, right? But you can't calibrate the standard pedals without an adapter....right?
By the way, I tried some stuff with the Fanatec Software to solve this issue until my McLaren wheel got bricked....at least it would seem so.
Weeks of waiting -> one moment of joy when the package arrived -> weeks of waiting
Thanks in advance for your help! From what I've read, this community is awesome! :)
Comments
Have you set a minimum in the driver? or reset the minimum?
As far as it is possible to access the standard pedals with the software, yes.
Hi Oliver! I have the same problem since gt dd+ extreme. they asked me to return the pedal for repair. (csl pedals, no load cell) and I also think the problem is software. now here I am with my new steering wheel, without pedals....
Szia David.
Ugy gondolom,hogy az en Clubsport pedals V3- nak tonkrement a Load cell.
Ha neked is ez a problemad akkor esetleg tudsz mondani valami biztatot.
Megoldodott a problemad?
Sajnos sehol nem talalok load cell-t.
Hol tudnek beszerezni?
A Fanatec weboldalon nincs most ( Junius 1 2024 )
Ha igen akkor hol?
Sok kommentben olvasom,hogy a Fanatecnek kell irni.
Pontosan hova esetleg te tudod azt. ( Costumer Service ? )
A valaszodat elore koszonom.Szep napot.Zsolt