Running DD2 with GSI Hyper P1 Wheel

Craig NorfleetCraig Norfleet Member
in Third-Party Hardware

Just installed a QR2 and a new Gomez Sim Industries (GSI) Hyper P1 wheel. With my trusty ClubSport V2.5 wheel, it was easy to start up the wheelbase with the torque key installed, press a button and high torque mode was enabled. But with the new wheel, I can't figure out how to do this. Anybody have any guidance they can share?

Is there a way to do this directly with Fanatec controller SW?

Comments

  • Reind DooyeweerdReind Dooyeweerd Member
    edited November 2023

    After base startup and with the low torque message in your screen rotate your steering wheel 90 degrees and a progress bar will decrease on the screen of your DD1 or DD2... it's as simple as that and it works every time when i use a non Fanatec steering wheel ;)

  • Craig NorfleetCraig Norfleet Member

    Thanks! That solved it!... Much better in full torque mode.

  • gschwind.stephan@outlook.comgschwind.stephan@outlook.com Member

    I will get my Hyper P1 on this Saturday. How did you connected it? Active USB, directly on your PC or with just an USB extension cable?

Sign In or Register to comment.