V3 Pedals Clutch will not set minimum when connect to CSW 2.5, but ok on usb port
Ian Goodes
Member
in Pedals
I have the V3 Pedals. if i connect them to my CSW 2.5 , the clutch remains at a min value of 50%. i cannot set it with the manual calibration to zero. also tried via the wheel, when in setup, left+right paddle + d pad down.
if i connect the pedals direct to a usb port then all is good , the clutch reads zero, but the i loose the BRF function on the brake.
anyone any clues.
i have the beta drivers 365 installed.
Regards
Comments
Did you come up with a solution?
Same problem on DD1 current FW 3.81.