F1 22 (Xbox) - Fanatec Recommended Settings

Dominic BrennanDominic Brennan Member, Administrator
in F1 20xx

General Notes:

  • The settings below are considered to be reasonable baseline values for F1 22 (Xbox). They might not suit all tastes and driving styles, but they are a good starting point.
  • In order to apply the suggested settings correctly, it is important to assign both the Tuning Menu values AND the suggested In-Game settings together.
  • These settings assume you have updated all firmware from the latest Fanatec Driver package (available on the front page of the Fanatec website).
  • If you cannot access all the settings shown below, you are probably in the Standard Tuning Menu. To switch to the Advanced Tuning Menu, first enter the menu (short-press the Tuning button once), then press and hold the Tuning button for about four seconds.
  • You may see additional Tuning Menu settings depending on your connected devices. These additional settings are not relevant to force feedback, and are not listed here.
  • The settings for the CSL DD / Gran Turismo DD Pro are suitable for 5 Nm and 8 Nm (Boost Kit 180).
  • The settings for the Podium Wheel Bases assume you are in High Torque Mode. In Low Torque Mode, the same settings can be used, but with a higher FF value.


CSL DD / Gran Turismo DD Pro

Tuning Menu Settings:

  • SEN 2520
  • FF 100
  • FFS Peak
  • NDP 50
  • NFR 20
  • NIN Off
  • INT 3
  • FEI 100

In-Game Settings:

  • Vibration and Force Feedback: On
  • Vibration & Force Feedback Strength: 70
  • On Track Effects: 10
  • Rumble Strip Effects: 20
  • Off Track Effects 20
  • Wheel Damper: Off
  • Understeer Enhance: Off
  • Maximum Rotation (F1 & F2): 360
  • Maximum Rotation (Supercars): 900


Podium Wheel Base DD1 / DD2 / Podium Racing Wheel F1

  • SEN 2520
  • FF 45
  • FFS Peak
  • NDP 30
  • NFR 5
  • NIN Off
  • INT 3
  • FEI 100

In-Game Settings:

  • Vibration and Force Feedback: On
  • Vibration & Force Feedback Strength: 60
  • On Track Effects: 10
  • Rumble Strip Effects: 25
  • Off Track Effects 25
  • Wheel Damper: Off
  • Understeer Enhance: Off
  • Maximum Rotation (F1 & F2): 360
  • Maximum Rotation (Supercars): 900


Comments

  • Ertan PrelicErtan Prelic Member

    I tried these settings on Xbox Series S and they work fine, I would recommend to use them as starting point and then tweak little things if necessary.


    I have only one problem with using CSL DD on F1 22, after entering pause menu or starting practice/qualifying/race there is a delay around 1 sec long where you don't feel FFB on the wheel. And that can cause mistakes and possible crashes until you feel the FFB. Is there a way this can be fixed?

  • Jorge ElimendezJorge Elimendez Member

    This configuration no longer works after the latest firmware


    *dd pro

Sign In or Register to comment.