Pedals not Detected
Jack Brenton
Member
in Pedals
Hi all,
Just finished installing the CSL Elite Wheel Base V1.1 and the CSL Elite Pedals (non load-cell). Got it to work for a night and then just plugged it again and now the pedals are not being detected. The steering wheel and base are being detected just fine though (pedals are connected via RJ12 cable to the wheel base).
I've tried a bunch of suggestions while looking through the forums but have hit a dead-end. Here is what I have tried so far:
- Uninstalled and reinstalled Fanatec Drivers.
- Re-flashed firm ware
- Bought a new RJ12 cable (comes in today)
- I tried to connect my old fanatec pedals and it didn't even recognize it
I'm itching to back into sim racing... Any ideas?
Comments
I've also reached out to Fanatec Support but they told me to reinstall drivers and check the forum...
Maybe look at the connectors, see if a pin is bent or broken.
I tried that, it doesn't seem to have any broken pins but it is hard to tell.
Hello,
What was the problem?
Because I have exactly the same thing as you.
Thank you in advance
Fernand