V3 inverted Pedals; after loading new driver brake doesn't work again

Oliver DeppelerOliver Deppeler Member
in Pedals

Hello

I downloaded all new drivers to my DD1 and V3 inverted.

PC Driver 402

DD Firmware 684

Podium wheel base motor firmware 40

Clubsport V3 I Vers. 1.31

After the download I can not calibrate the brake. To set max and min sometimes the blue bar its flickering or it keeps hanging with the message "waiting" etc. After ca.15 trys it worked, but at the next day the brake didn't work again. I download the pedal driver 1.31 more times, always with the same result. I tried it with direct connect via ubs or direct to the dd1 (only one cable was always connected).

Have anyone an idea about this problem?

Thanks Oliver

Comments

  • Dominic BrennanDominic Brennan Member, Administrator

    Hi Oilver,

    The older pedals firmware should also be included with this driver. If you switch Firmware Manager to manual update, you can open the Updater and then use the button with 3 dots to select firmware version 1.30.

    If you still have issues or you would like to discuss this with tech support, please create a Support Ticket via the My Products section of your Fanatec account.


    [Fanatec Community Manager]

  • Oliver DeppelerOliver Deppeler Member

    I tried it with the version 1.30, but the same result.

    I createt a support ticket and will see.

Sign In or Register to comment.