V3 brakepedal failing - sometimes the other ones - and not always

Andreas HartmannAndreas Hartmann Member
in Pedals

Hello,

i have a weird problem. Brakepedal is dead after cold boot, but not every boot, sometimes it works for days without problems. And i have had a dead throttle and clutch also.

When its happening i start driver control, change from manual to automatic or viceversa and pedals are back.

Any tips what that could be ? Am i on the eve of destruction ?



Pedals are connected to PC per USB, not to base

PC driver: 373

WB FW: 674

SW FW: 35

Pedal FW: 1.30

Comments

  • Dominic BrennanDominic Brennan Member, Administrator

    Hi Andreas,

    If you have a Fanatec wheel base then you should connect the pedals to that and see if the behaviour is the same. Ensure that you don't have both USB and RJ12 cables connected at once.

    In any case, I recommend that you open a Support Ticket via the My Products section of your Fanatec account.

    [Fanatec Community Manager]

  • Andreas HartmannAndreas Hartmann Member

    CSW2.5, yes but unfortunately thats not possible, i am a desktop racer, i put the base aside when i am done, cable would be a bit short ;). And the effect is sort of new, happening since a few weeks, pedals are here for ~2 years

Sign In or Register to comment.